Epec CAN Module Family CONTROL MODULE G08 / MAN DOCUMENT VERSION HISTORY Date Notes Document . Epec provides software tools for control system programming, adjusting, and testing. From the systems engineering viewpoint, it is not enough to have sufficient. Open and compatible. Embedded control systems are based on PLCopen and CANopen®, which make them easily scalable to meet requirements for both.
|Genre:||Health and Food|
|Published (Last):||24 January 2015|
|PDF File Size:||11.10 Mb|
|ePub File Size:||2.89 Mb|
|Price:||Free* [*Free Regsitration Required]|
PWM frequencies can be configured under software control in groups of outputs.
In other words, pin connects epfc load to positive supply voltage. Epec is a solution provider specialized in embedded control systems, vehicle computers and information logistics systems for mobile machines.
Bram Engineers De kracht van Mechatronics!
There eped, for example, outputs which source current and outputs which sink current. Closed light cast aluminium housing? The Color display needs extra facilities in order to have the limit B covered.
All applied cables should be properly shielded, bundled and grounded? In high impedance voltage input configuration they have low threshold voltage which is quite sensitive to interference signals.
Epec Control Module, Epec Control Module Suppliers and Manufacturers at
Memory functions shall remain class A. The system should be designed and constructed according to the Epec general mounting and cabling instruction document.
The programmability of CANs depends on the used programming environment as described in the following table: In other words, pins connect the load to the ground. So, the practical limits are lower but the maximum values of the table still give the basis for the estimation.
Inputs are divided into groups by the input impedance configuration. The pulse count and pulse frequency can be read from the pulse input channels. Generally, it is not recommended. The application program can also simultaneously monitor the actual state of the pin. Nominal supply voltage 24 VDC?
No scrapping fee will, however, be charged for products that are received by the manufacturer during the warranty period. Recommended operating voltage 24 VDC?
The buyer shall attach to the claim a possible error report or equivalent explanation of the grounds for the claim. The warranty does not cover possible expenses relating to travelling, accommodation, daily benefits, etc.
The first is a bit variable in the IX area just in the same way as with the pins without the PI features. Closed loops wiring can be achieved by connecting the GND eec from the sensor, actuator etc. Please refer CoDeSys 2. Test method ISOpulse 5? Any of these inputs can be logically paired with another similar input. The maximum rating is lowered in this case to 15 volts.
Epec 3724 Control Unit
Mounting position horizontal or vertical to allow water etc. The maximum frequencies given in the table below epdc such frequencies which make the module to freeze in practice if all inputs are connected to their maximum frequencies.
The manufacturer does not assume any responsibility for this product being fit for any particular application, unless otherwise epce stated in writing by the manufacturer. Mining Machines Monitoring Functions Following issues can be monitored by the application? Maximum pulse input frequency 20 kHz. Protection for plugs depends on cable processing? Is dependable for the other interrupt load in module for example heavy CAN-traffic can reduce maximum frequency. CAN2 is user programmable?
This product complies with those certifications and standards that are listed below. Eec loads can not be detected because the internal load resistor is connected to the ground.