ASTM F – Standard Specification for Pressure-rated Polypropylene (PP) Piping Systems. CSA B – Polypropylene (PP-R) Pipe and Fittings for. ASTM F “Pressure-rated Polypropylene (PP) Piping Systems”. Presented to the IAPMO Standards Review Committee on May 8, General: The. Find the most up-to-date version of ASTM F at Engineering
|Published (Last):||11 May 2007|
|PDF File Size:||1.89 Mb|
|ePub File Size:||4.34 Mb|
|Price:||Free* [*Free Regsitration Required]|
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
Link to Active This link will always route to the current Active version of the standard. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
The user shall consult the manufacturer to determine whether the material being transported is compatible with the polypropylene piping system and will not affect the service life beyond limits acceptable to the user. Historical Version s – view previous versions of standard. Included are criteria for materials, workmanship, dimensions and tolerances, product tests, and marking for polypropylene PP piping system components such as r2389, fittings, valves, and manifolds.
This abstract is a brief summary of the referenced standard. This specification establishes the f289 for polypropylene PP piping system components such as pipe, fittings, valves, and manifolds used in water service lines, hot-and-cold water distribution, hydronic heating, and irrigation systems to transport industrial process fluids, effluents, slurries, municipal sewage, etc. Work Item s – proposed revisions of this standard.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up f23889 date.
When tested according to the procedures provided f23889, the piping components shall adhere to specified requirements for workmanship, dimensions, longitudinal reversion, melt flow rate, impact resistance, thermal stability and oxidative induction time OIThydrostatic pressure, thermocycling, and oxidative stability in potable chlorinated water.
The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Awtm piping system components covered here are made to metric sizes and IPS schedule 80 sizes, and pressure rated for water service and distribution supply.