AS Telephone Line Interface And Speakerphone Circuit. is a CMOS integrated circuit that incorporates DC and AC line adaptation (DC-mask and. AS Datasheet PDF Download – Telephone Line Interface and Speakerphone Circuit, AS data sheet. austriamicrosystems AG AS datasheet, Telephone Line Interface and Speakerphone Circuit (1-page), AS datasheet, AS pdf, AS datasheet.
|Published (Last):||5 January 2018|
|PDF File Size:||5.6 Mb|
|ePub File Size:||18.3 Mb|
|Price:||Free* [*Free Regsitration Required]|
It can be calculated by the following equation: The new type of capacitor has a space-saving design with two, three or even ten identical capacitors connected in parallel on the same terminal to increase the capacitance.
It’s a community-based project which helps to repair anything. Side Tone A good side tone cancellation can be achieved by using the following equation: One can adapt side tone without changing the ACimpedance.
The user can also change the gain via Register Handsfree receive end gain See section “Handsfree”.
Internal pull-up resistor kOhm Disclaimer Devices sold by austriamicrosystems AG are covered by the warranty and datasheeet identification provisions appearing in its Term of Sale. It is also possible to re-write all registers periodically. The material herein may not be reproduced, adapted, merged, translated, stored, or used without the prior written consent of the copyright owner. Quickly Enter the access of compare list to find replaceable electronic parts.
AS & AS Single Chip Phone – Audio | PMT
The first four bits 7,6,5,4 are the addresses of the registers, the last four bits 3,2,1,0 are the data bits. It is recommended to re-write all registers after a line-break, as a line break may take long enough to discharge VDD, even when the MASK bit was set. This product is intended for use in normal commercial applications.
It is therefore recommended to keep these lines short, filter them by a discrete lowpass filter and reduce the clock speed accordingly.
AS2523 Datasheet PDF
Re-writing all registers also eases later software updates, as only register contents need to be changed, but no additional command lines need to be inserted. The material herein may not be reproduced, adapted, merged, translated, as25523, or used without the prior written consent of the copyright owner.
No Conf Tone This gain can be changed by programming from —7. Example of a typical power-up sequence A ss2523 power-up sequence will require the following programming. However, austriamicrosystems AG shall not be liable to recipient or any third party for any damages, including but not limited to personal injury, property damage, loss datazheet profits, loss of use, interruption of business or indirect, special, incidental or consequential damages, of any kind, in connection with or arising out of the furnishing, performance or use of the technical data herein.
As a safety margin however, it is recommended to re-write all registers after a flash Additional settings during line breaks If a line-break-detection brief interruption of the line while in off-hook state is implemented, the same rules apply as for a Flash: The soft clip circuit limits the output voltage as223 LS to 2V p.
Enhanced handsfree feature phones with CallerID and. Analog tone at RO Mask, Lh, Hf, Hook Mask: Line loss compensation setting 0 0 20mAmA Line loss compensation 1 0 mA Line loss compensation It prevents harsh distortion and acoustic shock. No obligation or liability to recipient or any third party shall arise or flow out of austriamicrosystems AG rendering of technical or other services. Specifications Contact Us Ordering Guides.
The Power down mode is ws2523 during Flash and Pulse dialing and for On-hook operation. Each register has 4 bit data width. Therefore, prior to designing this product into a system, it is necessary to check with austriamicrosystems AG for current information.
Each register has 4 bit data width. Digital volume control of Rx signals on AS only. AS datasheet and specification datasheet Download datasheet. Applications Enhanced handsfree feature phones with CallerID and extended displays The first ax2523 bits 7,6,5,4 are the addresses of the registers, the last four bits 3,2,1,0 are the data bits. Each register has a default setting see data sheetwhich xs2523 set after power-up of the chip.
The soft clip circuit limits the output voltage at Dahasheet to 1V p. This provides a maximum of independence of AC-impedance and side tone from each other.
AS Interface – Telecom. Rx-offset setting 0 0 0mV 0 1 12mV 1 0 40mV 1 1 mV This guarantees safe operation in case of unexpected loss of power during normal operation. Dual softclipping in handsfree mode on AS only.
datasheet for AS2523/4 by ams AG
Register Log in Shopping cart 0 You have no items in your shopping cart. However, electromagnetic pulses on the clock and data lines may cause unwanted programming of the chip. Copy your datasheer code and put on your site: Side tone adaptation selectable by external components.
All other trademarks are the property of their respective owners. Applications Enhanced handsfree feature phones with CallerID and extended displays. Timing The data format ass2523 writing to a register has the following form: The register contents cannot be read, they can only be written.